Part #HOL-130.00
Titanium Bezel Soldering Clamp

US$ 25.95

 

4-3/4″ x ½” X 1″

Made of titanium.

This is a multi-use tool for both soldering and cutting straight ends for bezel wires. No more worries about the ends coming apart or twisting – especially those thin ones. No stress, no frustration

SOLDERING

  1. Works best to mount Clamp onto a Third Hand.
  2. Squeeze gently behind the knob to release pressure on the screw while opening the tips at the same time.
  3. Slide bezel wire as shown, adjust the ends so they are touching each other with no gap in between. Tighten the screw just enough pressure to hold the bezel.
  4. Solder as usual.

Caution! Don’t touch the grip, it will be hot!!
The Clamp can be air cooled or, to speed up the procedure, pick up the whole assembly by the base and quench into a bowl of cold water.  Then loosen the grip, remove and finish as usual.

 

CUTTING WITH JEWELRY SAW
Perfect cuts on bezel wire, no filing needed.

  1. Mount Clamp on 3rd hand.
  2. Line up the marks, and insert onto the tips as shown on photo.
  3. Hold onto the tail end of wire and cut along the line between the tips with jewelry saw.
  4. This doesn’t need much pressure,  especially towards the end.

 

SHIPPING OPTIONS:

SMALL PACKET vs EXPEDITED SHIPPING with TRACKING & INSURANCE

I offer low cost shipping via Canada Post Small Packet that does not include TRACKING or INSURANCE. This means if your package does not arrive, (which usually takes 1 – 5 weeks) I am unable to track it and am not be responsible to replace it.

Please note that should you require TRACKING and INSURANCE for your order, Please contact us for shipping upgrade.

+

VIDEO TUTORIALS

USING THE BEZEL SOLDERING GRIP